User manual

11-8
NOTE
This boat is equipped with an electric bilge pump that automatically removes excess water from the
bilge while you are underway. However, some residual water remains that must be drained by removing
the drain plug.
Tighten the hull drain plug securely before launching the Skeeter boat. Clean any foreign material, such as dirt
or sand, from the threads before installing the drain plug.
3. Spray a rust inhibitor, such as Yamaha Silicone Protectant and Lubricant, on metallic parts to minimize
corrosion.
RUNNING
Section 11_horiz 11/3/03 2:45 PM Page 11-8