User Manual

11
Real Time Monitor Display
The Real Time Monitor display (Figure 6) shows the operating
status of the connected AirChek 2000/3000 pump.
Monitor Display Cell Readout
Pump Status .........................FLOW: Pump in Run mode
HOLD: Pump in Hold mode
FAULT: Pump in Flow Fault mode
PROG (HOLD): Pump program in memory, pump in
Hold mode
Flow .......................................current fl ow rate in mL/min
Volume ..................................volume of air pumped
Run Time ..............................total run time of pump since reset
Total Time .............................total run time of pump since factory calibration
Ba ery icon ..........................graphically displays ba ery life. The ba ery life is in-
dicated by a light-colored bar with low (-) charge indi-
cated on the le side and full (+) charge indicated on the
right side. A ba ery with a full charge is displayed by
the length of this light-colored bar. A long light-colored
bar (closer to the + end) represents a ba ery near a full
charge. A short light-colored bar (closer to the - end)
represents a ba ery near depletion.
The data in the cells is updated every 5 seconds. If the operation of the pump is
changed, the cells will display the previous values for up to 5 seconds before they
are updated.
Figure 6. Real Time
Monitor Display
SKC Real Time Monitor Window