User Manual

Ordering Information

PPI Samplers, require ﬁ lter, substrates, and support Cat. No.

Respirable PPI (gold), 2 L/min 225-380

Thoracic PPI (blue), 2 L/min 225-381

Respirable PPI (red), 8 L/min 225-383

Recommended Collection Filters for PPI, required for sampling

Select a ﬁ lter based on your application.

PVC Filters, 37 mm, 5.0-μm pore size, pk/100 225-5-37

PTFE Filters,*

37 mm, 2.0-μm pore size, with laminated PTFE support,

for metalworking ﬂ uids (NIOSH 5524), pk/50 225-27-07

MCE Filters, 37 mm, 0.8-μm pore size, pk/100 225-5

Filter Supports, required for sampling. Select either cellulose or stainless steel.

Support Pads, cellulose, 37 mm, pk/100 225-27

Support Screen, stainless steel, 37 mm, wide mesh, ea 225-26

Impaction Substrates, four required for each sample

Porous Plastic Discs,

-inch diameter, pre-oiled, ready-to-use,

disposable, pk/200

Limited shelf-life 225-388

Accessories

Multi-purpose Calibration Jar 225-111

Forceps, stainless steel, with non-serrated ﬂ at tips 225-8371

Filter-Keeper

™

, for transporting and storing 37-mm ﬁ lter samples, pk/10 225-8303A

* Back pressure on PTFE ﬁ lters can vary within the same lot.

§ If using PTFE Filter Cat. No. 225-27-07 as speciﬁ ed in NIOSH 5524 for Metalworking Fluids, follow the procedure

in NIOSH Dra Appendix for NIOSH 5524 at www.skcinc.com/instructions/38030.pdf to mitigate problems with

weight instability and subsequent high blanks following extraction. Failure to follow the procedure in the NIOSH

Dra Appendix will result in invalid samples.

For Disposable PPI Samplers,

visit www.skcinc.com/prod/225-3841.asp.

SKC Limited Warranty and Return Policy

SKC products are subject to the SKC Limited Warranty and Return Policy, which

provides SKC’s sole liability and the buyer’s exclusive remedy. To view the com-

plete SKC Limited Warranty and Return Policy, go to h p://www.skcinc.com/

warranty.asp.

Form 38038 Rev 1402