Owner's manual

9
Ordering Information
Development
Developed by Dr. Constantinos Sioutas of the University of Southern California in
partnership with the Mickey Leland National Urban Air Toxics Research Center
(NUATRC).
References
Misra, C., Singh, M., Shen, S., Sioutas, C., and Hall, P., “Development and Evaluation of a Personal
Cascade Impactor Sampler (PCIS),” Journal of Aerosol Science, 33, 2002, pp. 1027-1047
Ono-Ogasawara, M., Myojo, T. “A Proposal of Method for Evaluating Airborne MWCNT
Concentration,” Industrial Health, 49, 2011, pp. 726-734
Ono-Ogasawara, M., Myojo, T., “Characteristics of multi-walled carbon nanotubes and background
aerosols by carbon analysis; particle size and oxidation temperature,” Advanced Powder
Technology, 2012, http://dx.doi.org/10.1016/j.apt.2012.06.013
Singh, M., Misra, C., Sioutas, C., “Field Evaluation of a Personal Cascade Impactor Sampler
(PCIS),” Atmospheric Environment, 37, 2003, pp. 4781-4793
Sioutas, C., “Development of New Generation Personal Monitors for Fine Particulate Matter (PM)
and its Metal Content,” NUATRC Research Report No. 2, 2004, www.sph.uth.tmc.edu/mleland/
attachments/MLeland_Sioutas2.pdf
Description Cat. No.
Sioutas Personal Cascade Impactor 225-370
Pump for Sioutas Impactor Cat. No.
Leland Legacy Sample Pump
#
, 5 to 15 L/min, with Li-Ion battery pack,
CE marked 100-3002
Filters for Sioutas Impactor Cat. No.
After- lter, 37 mm PTFE*
with PMP support ring, 2.0 μm, pk/50, optional 225-1709
Collection Substrate ( lter for 4 stages), 25-mm PTFE (Ze uor
) with PTFE
support, 0.5 μm, pk/100, required 225-2708
* Back pressure on PTFE lters can vary within the same lot.
‡ Maximum operating temperature is 464 F (240 C) based on PMP support ring.
# Use in non-explosive environments only, not UL Listed for intrinsic safety.
Accessories Cat. No.
Defender Primary Standard Calibrator, 300 ml/min to 30 L/min 717-510H
Replacement Collector Plates, set of 4 P55016
Ring/Spacer Set includes 4 lter retainer rings, 9 O-rings, 1 PTFE spacer ring P51917
Retainer Rings only, pk/4 P20151
Forceps, precision stainless steel with serrated tips for inserting lters 225-13-1
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which
provides SKC’s sole liability and the buyers exclusive remedy. To view the com-
plete SKC Limited Warranty and Return Policy, go to h p://www.skcinc.com/
warranty.asp.