User Manual

16
Installing the Battery Pack
To enhance ba ery life, SKC ships ba ery packs separate from the pump.
Once installed, completely charge ba ery pack before operating pump.
1. Loosen the two case screws above and below the belt clip.
2. Slip the front edge of the battery pack under the belt clip and
position battery pack to engage the grooves in the case.
3. Slide battery pack toward the pump until it is fl ush with the pump
case on all sides.
4. Install two battery screws and tighten the case screws loosened in
Step 1.
5. Charge battery completely. For optimum charge, ensure pump is not
running during charging.
Replacing the Battery Pack
To enhance ba ery life, SKC ships ba ery packs separate from the pump.
Once installed, completely charge ba ery pack before operating pump.
1. Remove the two screws that secure the battery pack and loosen the
two case screws above and below the belt clip.
2. Carefully slide battery pack out from under the belt clip. Ensure that
the battery is kept level.
3. Slip the front edge of the new battery pack under the belt clip and
position battery pack to engage the grooves in the case.
4. Slide the battery pack toward the pump until it is fl ush with the
pump case on all sides.
5. Reinstall battery screws and tighten the case screws.
Back of pump
with battery
pack sliding out

Belt clip
Case screw
(not shown)
Ba ery pack screws
Case screw
Case grooves
Ba ery connector
Note:
Important Cautions/Warnings on next page
Note: