Owner's manual

Changing the Battery

1. Remove the six screws on the back of the pump case.

2. Grasp the white connector and pull it apart.

3. Gently pull the ba ery pack from the case.

Do not pull on red and black wires.

4. Remove the old ba ery pack and replace with the new ba ery pack.

5. Place the new ba ery pack inside the pump case with the label facing up.

6. Grasp the white connector from inside the pump case and the white con-

nector from the ba ery. Ensure the two pins inside the pump connector

align with the two sockets inside the ba ery connector. Push the two con-

nectors together ﬁ rmly until they click.

7. Ensure the connector is seated inside the pump case.

8. Replace the back plate on the pump ensuring the belt clip opens down-

ward.

9. Replace and tighten the six screws.

10. Charge ba ery completely.

Tampering with the battery pack voids the UL Listing for intrinsic safety

and any warranty.

Use of a repaired or rebuilt battery pack voids any warranty.

Failure to follow warnings and cautions voids any warranty.

For more information on SKC pump ba eries,

go to h p://www.skcinc.com/instructions/1756.pdf.