Operation Manual

 Deny: If you select “Deny” then all clients will be allowed to access Internet accept for
the clients in the list below.
 Allow: If you select “Allow” then all clients will be denied to access Internet accept for
the PCs in the list below.
 Filter client PCs by IP: Fill in “IP Filtering Table” to filter PC clients by IP.
 Add PC: You can click Add PC to add an access control rule for users by IP addresses.
 Remove PC: If you want to remove some PCs from the "IP Filtering Table", select the PC
you want to remove in the table and then click “Delete Selected". If you want to remove
all PCs from the table, just click the "Delete All" button.
 Filter client PC by MAC: Check “Enable MAC Filtering” to enable MAC Filtering.
 Add PC: Fill in “Client PC MAC Address” and “Comment” of the PC that is allowed to
access the Internet, and then click “Add”. If you find any typo before adding it and want
to retype again, just click "Reset" and the fields will be cleared.
 Remove PC: If you want to remove some PC from the "MAC Filtering Table", select the
PC you want to remove in the table and then click "Delete Selected". If you want to
remove all PCs from the table, just click the "Delete All" button. If you want to clear the
selection and re-select again, just click “Reset”.
Click Apply at the bottom of the screen to save the above configuration.
URL block
You can block access to some Web sites from particular PCs by entering a full URL address or
just keywords of the Web site.