Operation Manual

Sitecom Wireless Network UMTS Router 54G WL-610
50
9.6 QoS
The QoS can let you classify Internet application traffic by source/destination IP address and
port number. You can assign priority for each type of application and reserve bandwidth for
it. The packets of applications with higher priority will always go first. Lower priority
applications will get bandwidth after higher priority applications get enough bandwidth. This
can let you have a better experience in using critical real time services like Internet phone,
video conference …etc. All the applications not specified by you are classified as rule name
“Others”. The rule with a smaller priority number has a higher priority; the rule with a larger
priority number has a lower priority. You can adjust the priority of the rules by moving them
up or down.
Note:
If the total assigned bandwidth of higher priority applications is larger than the maximum
bandwidth provided by the WAN port, the other applications will not get any bandwidth.
Parameters Description
Enable/Disable QoS You can check “Enable QoS” to enable QoS function for the
WAN port. You also can uncheck “Enable QoS” to disable
QoS function for the WAN port.
Add a QoS rule into the table Click “Add” then you will enter a form of the QoS rule.
Click “Apply” after filling out the form and the rule will be