Operation Manual

Parameters Description

Enable/Disable QoS You can check “Enable QoS” to enable QoS function for the

WAN port. You also can uncheck “Enable QoS” to disable

QoS function for the WAN port.

Add a QoS rule into the table Click “Add” then you will enter a form of the QoS rule. Click

“Apply” after filling out the form and the rule will be added

into the table.

Remove QoS rules from the table If you want to remove some QoS rules from the table,

select the QoS rules you want to remove in the table and

then click "Delete Selected". If you want remove all QoS

rules from the table, just click "Delete All" button. Click

"Reset" will clear your current selections.

Edit a QoS rule Select the rule you want to edit and click “Edit”, then you

will enter the detail form of the QoS rule. Click “Apply”

after editing the form and the rule will be saved.

Adjust QoS rule priority You can select the rule and click “Move Up” to make its

priority higher. You also can select the rule and click “Move

Down” to make its priority lower.

Edit QoS Rule:

You can assign packet classification criteria by its local IP range, remote IP range, traffic type,

protocol, local port range and remote port range parameters. The parameters that you leave

as blank will be ignored. The priority of this rule will be applied to packets that match

classification criteria of this rule. You can limit bandwidth consumed by packets that match

this rule or guarantee bandwidth required by packets that match this rule.

Parameters Description

Rule Name The name of this rule.

Bandwidth You can assign the download or upload bandwidth by the unit of Kbps

(1024 bit per second). You can limit the maximum bandwidth

consumed by this rule by selecting “Maximum”. You also can reserve

enough bandwidth for this rule by selecting “Guarantee”.

Local IP Address Enter the local IP address range of the packets that this rule will apply

to. If you assign 192.168.0.3 – 192.168.0.5, it means 3 IP addresses:

192.168.0.3, 192.168.0.4 and 192.168.0.5

Local Port Range Enter the local port range of the packets that this rule will apply to.

You can assign a single port number here or assign a range of port

numbers by assigning the first port number and the last port number

of the range. The two numbers are separated by a dash “-“, for

example “101-150” means from port number 100 to port number