Operation Manual

together here when your AP is in AP Bridge modes.
6.2 Advanced Wireless Settings
You can set advanced wireless LAN parameters of this router. The parameters include
Authentication Type, Fragment Threshold, RTS Threshold, Beacon Interval, Preamble Type.
You should not change these parameters unless you know what effect the changes will have
on this router.
Parameters Description
Authentication Type There are two authentication types: "Open System" and "Shared Key".
When you select "Open System", wireless stations can associate with
this wireless router without WEP encryption. When you select "Shared
Key", you should also setup WEP key in the "Encryption" page and
wireless stations should use WEP encryption in the authentication
phase to associate with this wireless router. If you select "Auto", the
wireless client can associate with this wireless router by using any one
of these two authentication types.
Fragment Threshold "Fragment Threshold" specifies the maximum size of a packet during
the fragmentation of data to be transmitted. If you set this value too
low, it will result in bad performance.
RTS Threshold When the packet size is smaller the RTS threshold, the wireless router
will not use the RTS/CTS mechanism to send this packet.
Beacon Interval The interval of time that this wireless router broadcast a beacon.
Beacon is used to synchronize the wireless network.
Data Rate “Data Rate” is the rate this access point uses to transmit data packets. The The
25