Operation Manual

Chapter 6 Wireless Settings
6.1 Wireless Basic Settings
You can set parameters that are used for the wireless stations to connect to this router. The
parameters include Mode, ESSID, Channel Number and Associated Client.
Parameters Description
Mode It allows you to set the AP to AP, Station, Bridge or WDS mode.
Band It allows you to set the AP fix at 802.11b or 802.11g mode. You also can
select B+G mode to allow the AP select 802.11b and 802.11g connection
automatically.
ESSID This is the name of the wireless LAN. All the devices in the same wireless
LAN should have the same ESSID. Default ESSID for this device is:
Sitecom
Channel Number The channel used by the wireless LAN. All devices in the same wireless
LAN should use the same channel.
WLAN MAC This is the MAC address used by the Wireless interface of this AP when it
is in the station mode.
Clone MAC Click the “Clone MAC” button will copy the MAC address of your PC, that
you are using to configure the AP, to the WLAN MAC.
MAC address If you want to bridge more than one networks together with wireless LAN,
you have to set this access point to “AP Bridge-Point to Point mode”, “AP
Bridge-Point to Multi-Point mode” or “AP Bridge-WDS mode”. You have to
enter the MAC addresses of other access points that join the bridging.
Set Security Click the “Set Security” button, then a “WDS Security Settings” will pop
up. You can set the security parameters used to bridge access points
24