Operation Manual

Routing
These screens define routing related parameters, including static routes and
RIP (Routing Information Protocol) parameters.
Routing Table Flags Indicates the route status:
C = Direct connection on the same subnet.
S = Static route.
R = RIP (Routing Information Protocol) assigned route.
I = ICMP (Internet Control Message Protocol) Redirect route.
Static Route Click Add to add a new static route to the list, or check the box of
an already entered route and click Modify. Clicking Delete will remove an entry
from the list.
RIP mode Globally enables or disables RIP.
Auto summary If Auto summary is disabled then RIP packets will include sub-
network information from all sub-networks connected to the router. If enabled,
this sub-network information will be summarized to one piece of information
covering all sub-networks.
Table of current Interface
RIP parameter Interface The WAN interface to be configured.
Operation Mode
Disable: RIP disabled on this interface.