Operation Manual

WL-308 Gaming Router Full Manual
36
PPPoE (Point-to-Point Protocol over Ethernet)
The WAN interface can be configured as PPPoE. This type of connection is usually
used for a DSL service and requires a username and password to connect.
Select the PPPoE from the My Internet Connection drop-down list.
 Address Mode: PPPoE can be used with a dynamic or static IP address. If
you select the Dynamic IP radio button, then the IP address in the next field
is not required. However, if you select the Static IP radio button, then the IP
address in the next field is required.
 User Name: Specify the user name which is provided by your ISP.
 Password: Specify the password which is provided by your ISP, and then
verify it once again in the next field.
 Service Name: Specify the name of the ISP.
 Reconnect Mode: Select a reconnection time: Always on (A connection to
the Internet is always maintained), On demand (A connection to the Internet