Operation Manual

● Connect the power cable and the IDE cable on the network drive case to
the power and IDE connector on the hard disc.
Note: The red wire on the IDE cable must be connected to 'Pin1' on
your hard disc. Usually 'Pin1' points towards the power
connector on the hard disc.
Note2: Please make sure the jumper on the hard disc is set to
'master' position.
Note3: Information about jumper settings and pin layout can usually
be found on the label on your hard disc.
● When the cables are connected, place the hard disc in the network drive
case.
● Turn the drive case upside-down, and fasten the drive to the network
drive case by using the provided screws.