Operation Manual

Setup using the Windows Wizard
Initial setup should be performed using the supplied Windows-based setup Wizard. This
program can locate the Network Camera even if its IP address is invalid for your network.
You can then configure the Network Camera with appropriate TCP/IP settings for your
LAN. Subsequent administration can be performed with your Web browser, as explained in
Chapter 5 - Web-based Management.
Setup Procedure
Insert the supplied CD-ROM into your drive. The Sitecom CDROM Menu will
automatically start.
• Click the Install Utility button to start the installation of the Monitor/Playback/IP
Recorder/Setup-wizard Utilities.
• Follow the prompts to complete the installation.
• When the installation has finished, the Monitor utility will be launched.
• When the camera hasn’t been configured yet, you will see the Welcome screen
shown below.
• Click the Setup Camera button to start the setup Wizard
• The next screen, shown below, will list all the Network Cameras on your LAN.