Operation Manual

5
network.
1.5 Cabling
Through Ethernet Port
Connect the LAN cables: Use standard LAN cables to connect the PCs to the LAN ports
(switch) on the homestation.
Make sure that all connected devices are turned on. Please, check that the PWR, LAN LNK
and ADSL SYN LEDs are lit. If they are not, verify that you are using the proper cables.
If the cables are connected and the LEDs are lit normally, please go to section “3.
Configuring the Network Properties” to modify the network settings.
Through USB Port
The product can be used as a Network Adapter on your PC. That means you do not have to
install a network adapter first on your PC before connecting the DC-214/216 ADSL
Homestation. Just connect the supplied USB cable to the USB port of the ADSL Homestation
and connect the other end to the PC.
Make sure that all connected devices are turned on. Please, check that the PWR, LAN LNK
and ADSL SYN LEDs are lit. If they are not, verify that you are using the proper cables.
If the cables are connected and the LEDs are lit normally, please go to section “2.
Installing the USB Driver” below to setup this device.
Connect ADSL/power
Connect your ADSL cable to the LINE port on the homestation.
Connect the power adapter to the homestation. Only use the adapter that is delivered with
your homestation. Connect the power cord to power inlet and turn the power switch on.