Operation Manual

2. Hardware installation
2.1 Panel Layout
2.1.1 Front Panel
M1&M2 System status indicators, Green. M1 is flashed once per
second to indicate system is alive. When system is
busy, M2 is lighted.
WAN/Link Link status indicators, Green. The LED flickers when the
corresponding port is sending or receiving data
LAN/Speed
WAN/Speed
10/100 status indicators, Green. The LED flickers when
the corresponding port is transmitting or receiving data
in 10 or 100Mbps.
LAN/Link Link status indicators, Green. The LED flickers when the
corresponding port is sending or receiving data
RESET To reset system settings to factory defaults, please
follow the steps:
Power off the device,
Press the reset button and hold,
Power on the device,
Keep the button pressed about 5 seconds,
Release the button,
Watch the M1 and M2 LEDs, they will flash 8 times and
then M1 flash once per second.