Operation Manual

DC-202 xDSL/Cable Broadband router
10
Rear Panel
Reset Button WAN port
(10/100BaseT)
10/100BaseT
LAN connections
Power port
This button has two (2)
functions:
Reboot. When pressed and
released, the DC-202 will
reboot (restart).
Clear All Data. This button
can also be used to clear ALL
data and restore ALL set-
tings to the factory default
values.
To Clear All Data and
restore the factory de-
fault values:
Power Off.
Hold the Reset Button down
while you Power On.
Keep holding the Reset
Button for a few seconds,
until the RED Status LED on
the front panel has flashed
TWICE.
Release the Reset Button.
The DC-202 is now using the
factory default values.
Connect the DSL
or Cable Modem
here. If your
modem came with
a cable, use the
supplied cable.
Otherwise, use a
standard LAN
cable.
Use standard LAN
cables (RJ45 connec-
tors) to connect your
PCs to these ports.
Note:
Any LAN port on the
DC-202 will automati-
cally function as an
"Uplink" port when
required. Just connect
any port to a normal
port on the other hub,
using a standard LAN
cable.
Connect the
supplied power
adapter here.