Operation Manual

46
Routing
These screens define routing related parameters, including static routes and
RIP (Routing Information Protocol) parameters.
Routing Table Flags Indicates the route status:
C = Direct connection on the same subnet.
S = Static route.
R = RIP (Routing Information Protocol) assigned route.
I = ICMP (Internet Control Message Protocol) Redirect route.
Static Route Click Add to add a new static route to the list, or check the box of
an already entered route and click Modify. Clicking Delete will remove an
entry from the list.
RIP RIP mode Globally enables or disables RIP.
Auto summary If Auto summary is disabled, then RIP packets will
include sub-network information from all sub-networks connected to the router.
If enabled, this sub-network information will be summarized to one piece of
information covering all sub-networks.
Table of current Interface RIP parameter Interface The WAN interface to be
configured. Operation Mode Disable: RIP disabled on this interface.
Enable: RIP enabled on this interface. Silent: Listens for route broadcasts and
updates its route table. It does not participate in sending route
broadcasts. Version Sets the RIP (Routing Information Protocol)
version to use on this interface.