Troubleshooting Guide

Application
Product Warranty
The product is designed for moving waste water, raw and clean water.
Please note that the product is not meant to be used for pumping seawater and flammable,
corrosive, explosive or dangerous liquids.
PRORIL’s sole obligation under this warranty shall be limited to the repair or replacement of
any parts that the Seller determines, in its discretion, to be defective.
The warranty is void if the damage is caused by the following factors:
• Improper installation
• Deficient maintenance
• Damage caused by improper use, or abuse.
• Third party modifications made or attempted to alter the pump.
• Normal wear and tear
• The pump has been used for purposes other than those for which it is intended.
PRORIL assumes no liability for the following:
• Body injuries
• Material damages
• Economic Losses
PRORIL reserves the right to change design and specifications without prior notification.
‐ Make sure the pump is properly secured, and cannot roll or fall over.
‐ Always lift the pump by its lifting handle or by using suitable equipment. Never lift the
pump by the motor cable or hose.
‐ Let the pump run in the clean water after use in order to extend the
life span of the pump.
‐ Choose a location free from heat, dirt, humidity, and vibrations if the pump is stored
for an extended period of time.
‐ In cold climates, do not allow water in the pump to freeze.
‐ After an extended storage time,the pump should be inspected before use:
• Attention! Disconnect power cable before inspecting the pump!
• Turn the impeller by hand before using the pump.
• Check the seals and the cable entry.
Transportation and Storage