User manual

6 Setup
6.1 Setup wizard
When the device is switched on for the rst time, a setup wizard is started to set the
date and time as well as the network connection. The device is then ready for use.
In the ( ‘System settings’
) you can change these settings at any time and also restart
the setup wizard.
1. Choose ‘YES’ to start the setup wizard.
2. If you select ‘NO’ , the subsequent display asks whether you want to start the
setup wizard the next time you turn on the device.
ð
The system starts without conguring the time and date or the network
settings and displays the main menu.
If the device is disconnected from the power supply before the setup wizard
has nished, it will start again the next time the device is switched on.
6.1.1 12 / 24 hour display
Choose ‘Set 12/24 hour’ and then select the desired option to display the time
in 12 or 24 hour mode.
6.1.2 Time / Date
Time and date can be entered manually or updated automatically. With the auto‐
matic update, time and date are automatically synchronized with external clocks.
The automatic update takes place via DAB, FM or the Internet. Select the mode you
normally use for the clock to be updated. DAB and FM use the time signals trans‐
mitted via the radio stations. In network mode, the time signal of the "Frontier Silicon
Internet" radio portal is used as soon as the device is connected via a network.
1. Select one of the displayed options.
2. Select your time zone when updating over the network.
3. If there is a daylight saving time change in your country, the time updated via
the network may dier by one hour. To correct this, enable the ‘Daylight
savings’ option during winter time.
Automatic update
Setup
MP2
15