User guide

13
Step 2: Install the Dash or Vent Mount
Depending on your situation, you can either choose to use the Dash Mount
or the Vent Mount.
IMPORTANT! When you install the chosen mount, do not attach the dock
to the mount. All cables should be attached to the dock prior to
connecting the dock to the mount.
Installing the Dash Mount:
CAUTION! The adhesive used on the Dash Mount may be
difficult to remove. Do not install this mount on leather
surfaces (contact your vehicle dealer if you are unsure about
your dash surface), and make sure the air temperature is at
least 60°F (15°C) during installation. If it’s not at least 60°F,
turn on the heater in your vehicle to bring the temperature
up to 60°F.
1 Locate a flat surface for the Dash Mount. Make sure there is ample
room for the PowerConnect Vehicle Dock and Onyx Radio when
installed.
2 Set the orientation of the Dash Mount before adhering it. Loosen
the knob and adjust the adhesive foot for the location you selected
in “Step 1: Choose
a Location for Your
Radio” on page 11:
•Option 1 & Option 3
should be oriented
as I.
•Option 2 should be
oriented as II.
II
I
Vehicle Installation