Owner's Manual

Tour with Vehicle Kit User Guide

Installation

Pickup Truck

1. Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around the

windshield and tuck the antenna cable underneath it.

2. Continue tucking the cable underneath the windshield molding around the windshield to the

lowest corner.

3. At the lowest corner of the windshield, route the cable out of the windshield molding and into the

rubber weather stripping around the door opening. Lift the weather stripping from the opening

and tuck the cable inside it, then replace the weather stripping. Run the

cable inside of the weather stripping to the bottom of the door opening.

4. Pull the cable out of the weather stripping at the bottom of the door

opening and route it under the carpet toward the dashboard. Coil any

excess cable in a hidden location, such as under the carpet, keeping it

away from any vehicle pedals or controls. Secure the excess cable with

wire ties.

5. Bring the end of the cable out at the PowerConnect Vehicle Dock

location. Leave yourself enough cable so you can easily connect it to the

antenna connector of the dock.

6. Continue with “Step 5: Connect the Magnetic Mount Antenna and PowerConnect Power

Adapter” on page 20.

Step 5: Connect the Magnetic Mount Antenna and PowerConnect

Power Adapter

1. Plug the Magnetic Mount Antenna into the silver ANT connector on the

Powe rConnect Vehicle Dock.

2. Insert the PowerConnect Power Adapter into your vehicle’s cigarette

lighter or power adapter socket.

3. Plug the PowerConnect Power Adapter into the red PWR connector on

the dock.

AUDIOANT PWR FM

AUDIOANT PWRFM