Owner's Manual
Table Of Contents
- Tour Feature Guide
- Radio Views
- Introduction
- Feature Summary
- Now Playing Screen
- Side Panel Soft Buttons
- Satellite Connectivity
- Internet Connectivity
- Loss of Satellite Signal or Loss of Internet Connection Switching
- Setup Guide
- Audio Option Solutions
- Software Updates
- Content Tuning
- Voice Search
- Related Content Suggestions
- For You Recommendations
- Channel Categories
- Xtra Channels
- On Demand
- Personalized Stations Powered by Pandora
- Pause, Rewind, Replay
- Favorites
- Alerts
- TuneStart
- Start Over
- Jump
- Block Explicit
- Show/Hide Channels
- Metadata Scrolling
- User Interface & Navigation
- Connecting to the Internet
- FCC & IC Statements
- Important Information
- Quick Start Guide
- Warranty
- Safety and Care Information
2
3
AUDIO ANT PWR FM
4
AUDIO ANT PWR FM
A. B.
C.
Specifications
System
Power Requirements: 9-16 V DC,500 mA (max)
Operating Temperature: -4°F to +140°F (-20°C to +60°C)
Audio Output: 1.0 V
rms
(max)
Tour Radio
Dimensions: 4.7 in (W) x 2.9 in (H) x 0.7 in (D)
119 mm (W) x 74 mm (H) x 18 mm (D)
Weight: 5.0 oz (142 g)
Power
Connect Vehicle Dock
Dimensions: 4.0 in (W) x 2.4 in (H) x 1.2 in (D)
102 mm (W) x 61 mm (H) x 31 mm (D)
Weight: 1.6 oz (46 g)
Audio Connector: 1/8 in (3.5 mm) female
Antenna Connector: SMB male
Power
Connect Power Adapter
Dimensions: 3.7 in (W) x 1.7 in (H) x 1.3 in (D)
94 mm (W) x 43 mm (H) x 34 mm (D)
Weight: 2.4 oz (69 g)
Input / Output: 9-16 V DC / 5 V DC, 1.5 A
Cable Length: Approximately 4.6 ft (1.4 m)
Vehicle Antenna
Type: SiriusXM Magnetic Mount
Connector: SMB female, right angle
Cable Length: Approximately 23 ft (7.0 m)
Aux In Cable
Connectors: 1/8 in (3.5 mm) stereo male to
1/8 in (3.5 mm) stereo male
Cable Length: Approximately 4 ft (1.2 m)
Route the Antenna Cable
NOTE:
These instructions are for a sedan or coupe where the antenna is mounted above the
front windshield. The Tour User Guide (with Vehicle Kit) has detailed antenna cable routing
instructions for all types of vehicles. Go to www.siriusxm.com/guides for the User Guide.
A. Tuck the antenna cable under the
windshield rubber molding and run
it to the nearest corner.
B. Route the cable out of the molding
and into the rubber weather
stripping around the door opening.
C. Lift the weather stripping. Tuck and
run the cable inside it to the bottom
of the door opening. Replace the
weather stripping.
D. Pull the cable out and route it to Tour.
E. Plug the Magnetic Mount Antenna connector
into the silver ANT connector at the rear the
PowerConnect Vehicle Dock.
TIP: Include enough slack in your routing to accommodate open doors or the hood lid. Coil
any excess cable in a hidden location and keep it away from any vehicle pedals or controls.
Radio
Location
A. Mount the Magnetic Mount Antenna outside your vehicle, on a clean and
dry horizontal surface that will always face the sky.
B. Choose the location for the antenna according to your type of vehicle.
Center it between the left and right sides, and away from other antennas.
TIP: Use the Alcohol Prep Pad to clean the surface.
Sedans and Coupes
(above front windshield or rear window)
Pickups
(above front windshield)
Mount the Magnetic Mount Antenna
SUVs
(rear of roof)
Convertibles
(leading edge of trunk)
A. Insert the PowerConnect Power Adapter into your vehicle’s cigarette
lighter or power adapter socket. Plug the other end into the red PWR
connector at the rear of the PowerConnect Vehicle Dock.
B. Use the wire guide on the top of the dock to organize the wires
connected to the dock.
C. Place Tour into the dock.
Connect the PowerConnect Power
Adapter
5