Owner's Manual

Step 8: Permanently install the FEA
NOTE: IF YOU ARE MOUNTING THE FEA IN THE VEHICLE'S HEADLINER, SKIP THIS STEP.
When you are satisfied with the FEA's mounting location, remove the suction cup mounts
and peel the backing
off the bead and arrow adhesive mounts. Clean the area where the
FEA will be attached with the alcohol swab. Permanently adhere the FEA in the same
position
on the glass (or A-pillar), making certain the wire is taut and is as straight as
possible (see Figure 42). If necessary, use the cable guides to hold the cable.
REMOVE REMOVE REMOVE
ADHESIVE BACKING
BOTH SUCTION CUPS ADHESIVE BACKING
FROM ARROW ~ .. FROM BEAD
L0 . .. .f etb!=l Iel lel-f
1
~ THIS THINNER PORTION OF THE FEA ~ USE THE C~LE GUIDJS TO HO~ THE CABLE
SHOULD
BE TAUT WHEN THE FEA IN POSITION UNTIL IT REACHES
IS PERMANENTLY ADHERED THE INNER TRIM
OR MOULDING
Figure 42
[ Installation] 59