Owner's Manual

3. INSTALLATION AND WIRING CONNECTIONS
Before Installation
1. Before starting, be sure to disconnect the battery's negative "-" terminal to
prevent accidents due to short-circuits.
2. Location - Consider safety and operability when selecting a place
for installation.
Avoid the following.
• Locations where the unit will
hamper or interfere with driving.
• Locations where the unit could injure passengers if the car stops suddenly.
• Locations exposed to direct sunlight
or hot air from the heater, etc.
• Locations where the unit may be exposed to rain
or water.
3. Be sure to use the included screws and brackets. Screws other than those
supplied could damage'the unit.
Case
1--------
1
I
I
1
J
I
I
I
l..- _
8mm max.
Case
oIH:::::ge
4. When drilling holes to mount the receiver, be sure to check beforehand that
there are no obstructions
or items on the other side that could be damaged (fuel
tank, wire harnesses
or other electronic devices).
Accessories
Q) Mounting bracket 2 pieces
~ Mounting screw 4 pieces
@ Canoe clip 4 pieces
® CeNET cable 1 piece
4