Owner's Manual

SIRIUS~
SATELLITE RADIO
Antenna Installation
Once you have selected the correct mounting location (see previous section,
Mounting Information), you are ready to install the antenna.
1. Clean the area where the antenna and rubber antenna cable cover/tail will
be mounted with the supplied alcohol swab.
2. Connect the rubber antenna cable cover/tail to the antenna cable, making
sure that the strain-relief on the antenna seats into the rubber antenna
cable cover/tail groove. Route the antenna cable through the wire channel
in the rubber antenna cable cover/tail. Do not yet peel the protective strips
from off the adhesive.
ANTENNA
(UNDERSIDE)
PROTECTIVE STRIPS
ANTENNA
CABLE
ADHESIVE
RUBBER ANTENNA
CABLE COVERITAIL
3. Temporarily position the antenna and rubber antenna cable cover/tail in the
selected mounting area. Next, route the remainder of the antenna cable to
where the SIRIUS receiver is located
in the vehicle according to the
instructions following for the specific type of vehicle. Beware of the
following when routing the antenna cable:
• Do not pull the antenna cable across sharp edges damaging
it.
• Do not crimp, kink, chafe, or twist the antenna cable.
• Avoid positioning the antenna cable across sharp edges which may
eventually cut into the antenna cable.
• Keep the antenna cable away from areas where it could become
entangled
in the driver's or passenger's feet.
• Keep the antenna cable away from extreme heat, such as the
exhaust system of the vehicle.
• Avoid routing the antenna cable near any moving parts.