Owner's Manual

6. SIRIUS OPERATION
Selecting SIRIUSSIRIUS SATELLITE RADIO modes
Press the [SAT] button or the [FNC] (FUNC) button to select the SIRIUS mode.
The SIRIUS indication lights up when SIRIUS mode is selected.
Notes:
• The [SAT] button selects the SIRIUS mode directly. Some head units do not have
a [SAT] button. If not, press the [FNC] (FUNC) button until SIRIUS is selected.
• The [FNC] (FUNC) button selects the external devices connected to the source
unit
in order, for example: AM/FM mode ~ DAB mode ~ SIRIUS mode ~ CD
mode ~ CD changer mode ~ etc.
Selecting a band
Press the [BND] button to select a band. Each press
of the button changes the
display as shown below.
SR1 ~ SR2 ~ SR3 ~ SR1 ...
* The currently received band is displayed in the function mode indication.
* Models without a function mode indication display the band name and channel
number
in the display.
• Information displayed during reception
The following information is displayed when SIRIUS Satellite Radio cannot be
received normally.
• UPDATING: when the receiver is turned
on the first time or after a reset. Do not
turn power off during this time as the receiver is downloading the channel guide.
• ACQUIRING: when there has been a temporary loss
of signal and the receiver is
attempting to reacquire a signal. ("LINKING" is shown on an 8-digit display)
• INVALID CH: a channel without a broadcast has been selected
("INVLD CH" is shown
on an 8-digit display)
• NO SIGN-UP: a channel not available
in your subscription
• ANTENNA: no antenna is connected or there is a problem with the antenna
Switching the display
1. Press the [DISP] (D) button to select the desired display.
The main display or the clock display appears each time you press the [DISP] (0)
button.
2. In the main display, press and hold the [DISP] (0) button for 1 second or longer
to cycle between the following display modes:
Channel
name~ song title ~ artist name ~ category name ~ channel name
~ ...
Notes:
• The display shows the abbreviated channel name for 2 seconds when a station is
selected before returning
to the chosen display mode.
• Scrolling starts when the channel name or other text has been displayed for 2
seconds. When scrolling finishes, the initial characters appear. To start scrolling
again, press the [ADJ] button.
11