SIRIUS" SIRIUS Satellite Radio User Manual
Thank you for purchasing this product. * Please read this user's manual in its entirety before operating this equipment. * After reading this manual, be sure to keep it in a handy place (e.g., glove compartment). * Check the contents of the enclosed warranty card and keep it carefully with this manual. Contents 1. FEATURES 1 2. PRECAUTIONS 2 3. INSTALLATION AND WIRING CONNECTIONS 4 4. SYSTEM EXAMPLES 7 5. CONTROLS 9 6. SIRIUS OPERATION 11 7. SPECIFICATIONS ..........................•.........
2. PRECAUTIONS 1. 2. 3. 4. 5. 6. 7. Upon initial startup or when starting after turning off the backup power supply, the receiver will take longer to play audio and may take up to 30 seconds after reception of the SIRIUS signal before audio is heard. Channel names are stored in memory 30 to 60 seconds after start of normal operation. If the power is turned off before the text data is written, it may not be correctly displayed on the next power up.
SIRIUS" What is SIRIUS Satellite Radio? Over 100 streams of the best in-car entertainment and completely commercial-free music Only SIRIUS has 60 original music streams, from today's hits to R&B oldies to classical masterpreces. From authentic country and real bluegrass to cool jazz, hot latin, reggae, rock, and many more. Best of all, it's all commercial free, a Sirius exclusive.
3. INSTALLATION AND WIRING CONNECTIONS Before Installation 1. Before starting, be sure to disconnect the battery's negative "-" terminal to prevent accidents due to short-circuits. 2. Location - Consider safety and operability when selecting a place for installation. Avoid the following. • Locations where the unit will hamper or interfere with driving. • Locations where the unit could injure passengers if the car stops suddenly. • Locations exposed to direct sunlight or hot air from the heater, etc.
Installation Example (Installing the unit under the driver's seat) 1. Attach the mounting brackets
How-,to,Gonnect 1.··CeRETCable Orient the CeNET cable inthe direction shown in the figure and insert it until it is locked in position. To remove the CeNET cable, pull it QY lightly·grasping the slide cap @ in your fingers. 2. SIRIUS antenna * Make sure power is "Off'. Connect a SIRIUS antenna (sold separately) to the SIRIUS antenna terminal and press until locking tab engages. To disconnect, make sure power is "Off', then press the rear of the locking tab to release.
4. SYSTEM EXAMPLES • Example 1 ® SIRlusii SIR-CL1 CD Main unit compatible with CeNET connection ~ CD changer compatible with CeNET connection @ CeNET cable (provided with the SIR-CL1) Using this cable, connect the SIR-CL1 to the main unit.
• Example2 @ SIRlusii SIR-CL1 ClJlRIOlICQlAPJllTlBU! SRlUSSATI!WTI!IlADIOREeeNeR ® RCA pin (audio) cable (sold separately) ~ SIRIUS antenna (sold separately) @ Front speakers CD SIRIUS controller (DSC920S, sold separately) ~ Connection cable (provided with the DSC920S) ® Audio systems with auxiliary or line-in connections 8
5. CONTROLS Source unit buttons, example 1 [ROTARY] [FNC] Source unit buttons, example 2 [ROTARY] [DIRECT] [<~J, --:---:-~~~~ [~>] [SCN] Notes: • • The illustrations show examples of two headunits with button functions. Since this manual covers several models, the names of some buttons vary by model. As shown below, this manual gives different button names when more than one name is used. [FNC] (FUNC) button, [SC] (SCN) button etc.
Display Items Source unit display, example 1 Operation status indication ~ : SIRIUS indication llimm: Manual indication Source unit display, example 2 Operation status indication .:r.-:. ~-:. .ft-:. ~-:. ..~-:. ~-:. £6-:' ~'i III" ''11811:11I11I•• e CAT 1 ~ :--: nlSC"".
6. SIRIUS OPERATION Selecting SIRIUSSIRIUS SATELLITE RADIO modes Press the [SAT] button or the [FNC] (FUNC) button to select the SIRIUS mode. The SIRIUS indication lights up when SIRIUS mode is selected. Notes: • The [SAT] button selects the SIRIUS mode directly. Some head units do not have a [SAT] button. If not, press the [FNC] (FUNC) button until SIRIUS is selected.
• The [ADJ] button is described in the source unit instruction manual either as the [T] (TITLE) button or [A-M] button. This refers to the function of the button labeled "ADJ" on the source unit panel. ADJ or etc. -ADJ Channel selection Channels are selected with the following buttons. • The [<~] or [~>] button (Seek Tuning) • A [DIRECT] button • The [SCN] (SC) button • The [CAT] (ROM) button * For details, see the following operation descriptions.
Notes: • When the name of a channel stored in memory is changed by SIRIUS, the display will show the new channel name immediately. It will not be removed from the preset channel location. • A channel stored in memory may be discontinued at the option of SIRIUS. If you attempt to access this channel from the preset location, the receiver will give you the "INVALID CH" or "INVLD CH" response. At that time, you may select another station to store in memory.
Scan function There are two scan modes: a category scan mode and a preset scan mode. During scanning, channels are displayed in abbreviated form and the display mode cannot be switched. • Category scanning In a category scan, broadcast channels in the same category as the current channel are selected about every 10 seconds. 1. Press the [SCN] (SC) button to start a category scan. 2. Press the [SCN] (SC) button, a [DIRECT] button, the [<.....] or [~>] button to cancel a category scan.
7. SPECIFICATIONS Receivinq Frequencies Satellite Terrestrial Power Power supply (Stand-alone mode only) Power consumption Physical Interface Commander Antenna CeNET connector 2322.293/2330.207 MHZ 2326.
SIRIUS® SATELLITE RADIO SIRIUS~ SIRIUS Magnetic Mount Satellite Radio Antenna
Thank you for purchasing the SIRIUS Magnetic Mount Satellite Radio Antenna. Your new SIRIUS Magnetic Mount Satellite Radio Antenna is designed to optimally receive signals from the SIRIUS satellites and terrestrial (ground) transmitters when mounted on the roof (or trunk) of a vehicle. This antenna has been approved by SIRIUS Satellite Radio, Inc. to receive signals under a variety of conditions within the SIRIUS North American coverage area.
SIRIUS~ SATELLITE RADIO & Caution and Warnings CAUTION: Because adhesive is used in the installation of the rubber antenna cable cover/tail, it is recommended that the antenna be installed at or above room temperature (68 degrees). Lower temperatures may cause the adhesive on the rubber antenna cable cover/tail to not adhere properly to the vehicle roof.
procedure which follows). This rubber antenna cable cover/tail provides two benefits: first, it locates the antenna the recommended distance from the rear window, rear door/hatch, or trunk edge to give the antenna the best view of the sky. Secondly, it conceals and protects the exposed antenna cable. The rubber antenna cable cover/tail has adhesive strips that hold it securely in place. The following illustrations show the recommended mounting locations of the antenna for several types of vehicles.
SIRIUS~ SATELLITE RADIO Antenna Installation Once you have selected the correct mounting location (see previous section, Mounting Information), you are ready to install the antenna. 1. Clean the area where the antenna and rubber antenna cable cover/tail will be mounted with the supplied alcohol swab. 2. Connect the rubber antenna cable cover/tail to the antenna cable, making sure that the strain-relief on the antenna seats into the rubber antenna cable cover/tail groove.
Sedan/Coupe: Route the cable along the rear window underneath the rubber molding. Use a plastic knife or other blunt object to lift the window rubber molding and tuck the antenna cable underneath the window molding. Route the antenna cable around and down the window to the lowest point, and into the vehicle trunk area using any existing vehicle cable/wire channel or wiring conduit, if possible.
SIRIUS~ SATELLITE RADIO cover/tail are correct, and continue to press firmly down on rubber antenna cable cover/tail for another 30 seconds. Note: At room temperature (68 degrees), maximum adhesion usually occurs within 72 hours. During this period, avoid car washes and other contact with the antenna and rubber antenna cable cover/tail. 6. Coil any excess antenna cable in a location where it can be hidden and secure it with wire ties. This completes the antenna installation.
SIRIUS~ SATELLITE RADIO SIRIUS Satellite Radio 1221 Avenue of the Americas New York, NY 10020 (888) 539-7474 www.sirius.com © 2004 SIRIUS Satellite Radio Inc.
