Owner's Manual
Table Of Contents
--_._---_
....
~==
l-------\5r:
•
"!f:.=
~=::==J.-
,-
,
I
I
,
..
'
------
• Pickup Truck:
1.
Use a blunt plastic
putty
knife or similar blunt tool
to
lift
the
rubber molding around
the
windshield and tuck the antenna cable
underneath it.
2. Continue tucking
the
cable underneath the windshield molding
around the windshield
to
the
lowest corner.
3.
At the lowest corner of the windshield, route the cable out of
the
windshield molding
and
into the rubber weather stripping around the
door opening.
Lift
the weather stripping from the opening and
tuck
the cable inside it, then replace the weather stripping.
Run
the cable
inside of the weather stripping to the
bottom
of the door opening.
4.
Pull the cable out of the weather stripping at the bottom of the
door
opening and route
it
under the carpet toward the dashboard. Coil any
excess cable in a hidden location, such
as
under the carpet, keeping
it
away from any vehicle pedals or controls. Secure the excess cable
with wire ties.
5. Bring the end of the cable
out
at
the
PowerConnect
Vehicle Dock
location. Leave yourself enough
cable
so
you can easily connect
it
to
the
antenna connector of dock.
6. Continue with "Step
5:
Connect
the Magnetic Mount Antenna and
PowerConnect Power Adapter"
on
page 39.
" 8
-'