Owner's Manual
Table Of Contents
,
Vehicle Installation
• Sedan/Coupe With Antenna Placed
at
the
Rear of
the
Roof:
1.
Feed
the antenna cable from
the
antenna underneath the rubber
molding around
the
rear window. Use a blunt plastic
putty
knife or
similar blunt tool
to
lift
the
rubber molding around the rear window
and tuck the antenna cable underneath the molding. Route
the
antenna cable around and down
the
window
to
the lowest point.
If
your rear window does not have rubber molding,
we
recommend
consulting a professional installer.
2. Route
the
antenna cable
out
of
the
window molding and into
the
rubber weather stripping around
the
trunk
opening.
Lift
the
weather
stripping from the opening and
tuck
the
cable inside it, then replace
the
weather stripping.
To
avoid sharp bends in
the
cable, run
the
cable inside the weather stripping
for
a few inches, then remove the
cable from the weather stripping inside
the
trunk. Keep the cable
away from hinges, gears, etc.,
that
could damage it.
3. Route
the
cable out
from the rubber
weather stripping and
along the
trunk
wall.
Continue routing the
cable into the vehicle
cabin through a conduit
or
along
an
existing
wiring harness.
4. Route
the
cable
through
the main cabin