Owner's Manual
Table Of Contents
• SUV:
1.
Feed
the antenna cable underneath the rubber weather
stripping of the rear tailgate window/door
and
route the cable
along the rear hatch.
Lift
the weather stripping from the
opening
and
tuck the cable inside it, then replace the weather
stripping. Pull the cable out from weather stripping
and
route
it
into the cabin under the interior trim. Avoid hinges or gears
that
could crimp or cut the cable.
2.
Route the cable through the SUV's main cabin area under the
interior trim, towards the front of the vehicle.
Use
a blunt
plastic
putty
knife or similar blunt tool
to
lift
the plastic
trim
just enough to tuck the cable under underneath. Avoid side
airbag locations
on
back pillars
and
above the doors. Airbag
locations are marked with "SRS" logos.
Be
careful not
to
crimp
or cut the cable.
3.
Bring the cable out
from the
trim
near
the front of the cabin
and route
it
under
the carpet toward
the dashboard or
console. Coil any
excess cable in a
hidden location, such
as
under the carpet,
keeping
it
away from
any vehicle pedals