Owner's Manual

Description of Tuner Display, Controls, and Connectors
Display/
Description
Control/Connector
Standby
Standby indicator light
is lit when power is connected to the
tuner and the
On/Off Switch is On
Sat
Satellite signal strength
All Off: No Signal
indicator lights One Light: Weak Signal Level
Two Lights: Good Signal Level
Ter
Terrestrial signal strength
Three Lights: Excellent Signal Level
indicator lights
All Flashing: Antenna not detected
Channel
Displays the currently tuned channel
Channel Tuning Knob
Used to tune the satellite radio channel
Antenna
Connects to the satellite antenna
L -
Audio - R
Left/Right RCA-type analog audio output connectors
Opt.
Audio
Toslink optical digital audio output connector
RS232
RS232 interface connector for tuner control
8-PIN
8-PIN DIN interface connector for tuner control and audio output
IR
Infrared connector
Control Switch
Switches control between
1. Left-most position: RS232
1 - 2 - 3
the RS232, a-PIN DIN, or
2. Center position: 8-PIN DIN
Infrared connector
3. Right-most position: Infrared
On/Off Switch
Turns the power to the tuner on and off
AC
Power Connector
Connection for AC power cord
[ Controls and Connectors ] 9