Owner's Manual
Table Of Contents
Connector
Control
Description
Switch
Position
Infrared
3 (Right-most)
This connection is typically used
in
older systems which
use
an
IR
blaster
to
control the SIRIUS tuner. Instead
of using the IR blaster, the
IR
signal can be hard-wired
directly into this connection. Note that this type
of
con-
nection only supports one-way control with no metadata
feedback available.
The audio should be connected using either the
LlR
RCA-type audio output jacks,
or
the optical audio output
connector. (You will need
to
purchase
an
optical audio
cable separately.)
Subscribing to the SIRIUS Service
Before you can listen to the SIRIUS service, you need
to
subscribe
to
the Sirius Satellite
Radio service. Until you subscribe, you will only be able to tune
to
channels 0 and 184.
To
subscribe,
do
the following:
1.
Be sure that the tuner is correctly installed as described
in
this manual, and that the
antenna is oriented to receive the SIRIUS signal.
2.
Turn the tuner on. Verify that it is receiving a good signal. The tuner must remain
on
dur-
ing the entire subscription process.
3.
The tuners's unique 12-digit SIRIUS
10
Number (SID) is
on
a label on the underside of
the tuner, and is also available on the tuners's packaging.
Write
the SID number down
in
the space provided near the end
of
this guide.
4.
Have your
credit
card handy and contact SIRIUS
on
the Internet at:
https://activate.siriusradio.com/
and follow the prompts to activate your subscription. You can also call SIRIUS toll-free at:
1-888-539-SIRIUS
(1-888-539-7474).
5.
When you have successfully subscribed
to
the SIRIUS service, and the tuner has been
updated with your subscription information, you will be able
to
tune
to
all the channels.
You are
now
ready
to
begin enjoying SIRIUS Satellite Radio's digital entertainment!
24
[Installation ]