Owner's Manual
Table Of Contents
CABLE INSTALLATION
Once
the antenna is mounted
according
to
the previous instructions, you can continue with
the cable portion
of
the installation:
1.
Using one
of
the
RG-6
cables you purchased separately, slide
the
rubber
boot
over the
cable connection. Attach
the
cable
to
the antenna and slide the
rubber
boot
over the
connection
to
provide a weatherproof seal. Install the cable tie around the cable directly
below
the rubber
boot
to
prevent the rubber
boot
from slipping
down.
Trim
off
the
excess cable tie. (Figure 14)
,,------~
Figure 14
2.
Route the remainder
of
the antenna cable into the home or building
to
where you are
locating the Splitter.
When
routing
the
antenna cable, be careful
not
to
pinch, squash,
kink,
or
crimp the cable,
or
cut, damage,
or
puncture the external
jacket
of
the antenna
cable.
3.
Connect
the cable from the antenna
to
the IN
port
on the Splitter. (Figure 15)
Note
that
you must use the Splitter.
[
Installation]
21