Manual

Vehicle Installation

Step 2: Install the Dash or Vent Mount

Depending on your situation, you can either choose to use the Dash Mount or the

Vent Mount.

IMPORTANT! When you install the chosen mount, do not attach the dock to the

mount yet. All cables should be attached to the dock prior to connecting the dock

to the mount.

Installing the Dash Mount:

CAUTION! The adhesive used on the Dash Mount may be difficult

to remove. Do not install this mount on leather surfaces (contact

your vehicle dealer if you are unsure about your dash surface), and

make sure the air temperature is at least 60ûF (15ûC) during

installation. If it’s not at least 60ûF, turn on the heater in your

vehicle to bring the temperature up to 60ûF.

1 Locate a flat surface for the Dash Mount. Make sure there is ample room

for the PowerConnect Vehicle Dock and Xpress

RCi

Radio when installed.

2 Set the orientation of the Dash Mount before adhering it. Loosen the

knob and adjust the adhesive foot for the location you selected in

“Step 1: Choose a Location for Your Radio” on page 16:

•Option 1 & Option 3

should be oriented as I.

•Option 2 should be

oriented as II.

I II