Owner's Manual

and above the doors. AlrbaQ locations are marked with "SRS"
loqos.
Be careful not to crImp or cut the cable.
4.
BrlnQ the cable out from the trim near the front of the cabin
and route It under the carpet toward
the dashboard or console.
Coli any
eKcess cable In a hidden location, such as under the
carpet, keeplnq It away from any vehIcle pedals
or controls.
Secure the
eKcess cable with wire ties (purchased separately).
5. BrlnQ the end of the cable out at the PowerConnect Vehicle
Dock location.
leave yourself enouqh cable so you can easily
connect It
to the antenna connector 01 the dock.
6. Continue with "Step
5: Connect the Maqnetic Mount Antenna
and
PowerConnect Power Adapter" on paQe 37.
• Pickup Truck:
1. Use a blunt plaslJc putty knife or sImilar blunt tool to lift the
rubber moldinq around the windshield and tuck the antenna
cable underneath It.
2. Continue tucklnQ the cable underneath the windshield moldinq
around the windshield
to the lowest corner.
3. At the lowest corner of the windshield, route the cable out of
the windshield moldlnQ and Into the rubber wealher strlpplnQ
around the door openlnQ.
lift the weather strlpplnq from the
openlnq and tuck the cable Inside II, then replace the wealher
strlpplnq.
Run the cable Inside of the weather stripplnQ to the
bottom
01 the door openlnq.
4. Pull the cable out of the weather strippinQ at the bottom of the