Owner's Manual

cable with wire ties (purchased separately).
4. BrinQ the end
of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself
enouQh cable so you can easily connect It
10 the antenna connector of the dock.
5. Continue with "Step
5: Connect Ihe MaQnetlc Mount Antenna and
PowerConnect Power Adapter" on paQe 37 .
• Convertible:
I. BrlnQ the antenna cable from the antenna Into the
trunk at the tront
edQe 01 the trunk lid. Keep any bends In the cable loose. Tape or
tie the cable alonQ the Inside 01 the trunk lid to the trunk lid hlnQe
strut.
Z. Allow enouQh slack In the cable so the trunk lid can easily open and
close and keep the cable away from hinQes, Qears, etc., that could
crimp
or cut it. Route the cable alonQ the trunk wall and Into the
cabin throuQh a conduit
or al0nQ an existlnQ wlrlnQ harness.
3. Route the cable thrOUQh the
main cabin
area under the
interior trim, towards the tront
ot the vehicle. Use a blunt
plastic putty knife
or similar
blunt tool to
lilt the plastic trim
just
enouQh to tuck the cable
under underneath. Avoid side
alrbaQ locations
on back pillars