Owner's Manual

,
,
•
•
•
'-"
•
'"
'.
•
,
•
I~-/
• Sedan/Coupe With Antenna Placed at the Rur of the Roof:
1. Feed the antenna cable from the antenna underneath the rubber
molding around the rear window.
Use a blunt plastic putty knife or
similar blunt tool
to lift the rubber molding around the rear window
and tuck the anlenna cable underneath Ihe molding. Route the
antenna cable around and down the window
to the lowest point. If
your rear window does not have rubber molding,
we recommend
consulUnq a professional Installer.
2. Route the antenna cable out of the window molding and into the
rubber wealher stripping around the trunk opening.
Lift the weather
stripping from the opening and tuck the cable Inside It, then replace
the weather stripping.
To avoid sharp bends in the cable. run the
cable inside the weather stripping for a lew Inches, then remove the
cable from the weather stripping Inside the trunk. Keep the cable
away from hinges, gears, etc.,
that could damage It.
3. Route Ihe cable out from Ihe rubber weather stripping and along
the trunk wall. Continue
routing the cable into
the vehicle cabin through
a conduit or along
an
existing wiring harness.
4. Route the cable through
the main cabin area under
the Interior trim, towards
the
front of the vehicle.
Use a blunt plastic putty
knife or similar blunt