User's Guide

22
Options 1 & 2: Aux In Cable Installation Instructions
1 Plug one end of the Aux In Cable into the AUDIO
connector on the Snap base.
2 Plug the other end into the auxiliary input jack
connection of your vehicle’s stereo system.
3 Turn on your vehicle’s stereo system. Set it to play input
from the auxiliary input source (or cassette mode if using
a cassette adapter). You should hear XM channel 247
through your vehicle’s stereo system. The installation is
complete. Proceed to “Subscribe” on page 26.
4 The audio level output of the Snap
can be increased or
decreased as necessary to match the audio levels of other
sources in your vehicle. Refer to “Set Audio Level” on
page 35.
If the signal reception is good, showing at least one antenna
signal strength bar in the upper right corner of the display
screen, but there is no audio when tuned to channel 247, be sure the vehicle’s stereo system is set
to the correct source, i.e., auxiliary input source (step 3). Also be sure that the audio level is set
high enough to be heard (step 4). Refer to “Troubleshooting” on page 38 for additional help.
AUDIO FM
Audio
Connector
Aux In Cable
Aux In
Optional Cassette
Adapter
Installation and Setup