Installation Guide

Internal OnGlass FM Antenna OnGlass Antenna Bracket

Installation

Step 1:

Install the On-Glass Antenna Bracket on the interior window surface over the antenna

element using the adhesive pad provided and the following steps. It may be mount-

ed either vertical or horizontal depending on the portion of the antenna element most

easily accessed. Select a bracket position that allows room to attach the Coupling

Clip and cleanly run cables without blocking the driver’s view. Install the on-glass

antenna Coupling Clip before routing the cable to avoid excess cable. See Figure 6.

a. Clean the mounting location on the glass for the On-Glass Antenna Bracket with

any household window cleaner that will remove grime. Be sure the surface is

completely dry before proceeding. You may need to use your vehicle’s air

conditioning and/or defogger to keep the cleaned surface dry during the

installation for the adhesive to set properly.

b. Remove the yellow liners from each of the four adhesive pads and press the

On-Glass Antenna Bracket firmly to the identified mounting location on the glass.

You can also view the alignment through the glass from outside the vehicle. You

will have only a limited amount of time to reposition the On-Glass Antenna

Bracket before the adhesive cures.

c. The On-Glass Antenna Bracket has alignment arrows on the side opposite the

adhesive pads. These arrows indicate the contact strip location on the base of the

bracket. Align the arrows with the on-glass antenna element to ensure direct

contact between the strip and the element. Press and hold the On-Glass Antenna

Bracket in place for 10 to 15 seconds.

d. Once the Bracket is in place, attach the Coupling Clip to the On-Glass Antenna

Bracket as shown in figure 6. Route any excess cable behind liners for a

professional look.

NNoottee::

Be sure to leave enough slack on the cable so that the contact

strip does not pull away from the on-glass antenna.