User Guide

TThhee ffoolllloowwiinngg sstteeppss wwiillll gguuiiddee yyoouu tthhrroouugghh tthhee iinnssttaallllaattiioonn ooff yyoouurr
XXMM SSuurreeCCoonnnneecctt
1. Install your XM Radio in your vehicle as described in your XM Radio
User Manual but do not connect the XM antenna plug to the dock
at this time.
2. Locate your vehicles FM antenna and determine the best routing
method to get the XM SureConnect output cable to the FM antenna.
(For external antennas (Figure 1b), the Coupling Clip needs to be routed
outside the vehicle. For internal on glass antennas (Figure 1c), all rout
ing is inside the passenger compartment and the Contact Bracket is used.
3. To route the output cable with Coupling Clip to your vehicle FM antenna,
follow the instructions on the next pages . There are separate instructions
for external antenna vs the internal on glass antenna. Follow the instruc
tions that apply to your vehicle’s antenna type. (This guide assumes you
have already installed your XM antenna per the instructions in your XM
radio user guide. The positions of the XM antenna in the illustrations
below is for example only. There is no need to change your XM antenna
installation.)
4. Connect the XM Antenna to the XM SureConnect antenna input, locat
ed on the coupler module about 2 feet from the end of the input cable (see
Figure 1a). Tuck any excess input cable and the coupler module behind
dash or in another hidden location for a professional looking installation.
5. Connect the XM SureConnect input cable to the XM radio or vehicle dock
antenna input.
Installation Setup
6