User's Manual

Accessories (sold separately)
We're always developing useful and clever accessories for your MyFi.
Check our Web sites, www.xmradio.com or www.delphi.com, or your
favorite electronics retailers frequently.
Troubleshooting
Your MyFi should provide you with trouble-free performance
without needing any servicing. If it does not appear to be working
properly, first try to remedy the problem by following these steps:
1. Attach all connections firmly and securely.
2. Make sure the battery is fully charged and has been properly
cycled.
3. Reset your MyFi by removing the battery cover and inserting a
paper clip into the hole marked “RESET” at the upper left hand
corner of the case. You can also reset your MyFi by removing the
battery, then reinserting it.
If you see this on the display: You should:
NO SIGNAL
Cause: the XM signal is being
blocked.
Move your MyFi away from
obstructed area, e.g. an under-
ground garage.
ANTENNA
Cause: possible problem with
the built-in or external antenna.
Connect the external antenna.
Make sure the cable and
connector are not damaged or
kinked.
If you are using the home stand
or car cradle, make sure the
home or car cradle antenna is
plugged in.
OFF AIR
Cause: the channel is not
currently broadcasting.
Tune to another channel.
LOADING
Cause: your MyFi is acquiring
audio or program information
from the XM signal.
This message should disappear
in a few seconds in good signal
conditions.
UPDATING
Cause: your MyFi is being
updated with the latest
encryption code.
Simply wait a few seconds until
the update is done.
---
Cause: you may have tried to
tune to a channel that you
have blocked or that you cannot
receive with your subscription
package.
To receive that channel, contact
XM Satellite Radio at
1.800.967.2346.