User's Manual

FLUSH MOUNT: Attach the included Velcro® pads
or adhesive pad to the back of your MyFi's vehicle
cradle. Stick the vehicle cradle onto a flat surface
in your vehicle, preparing the surface as
described below. Do not install the mount on a
leather surface. Doing so could permanently
damage the surface.
VENT MOUNT: Assemble the vent
mount as shown, if not already
assembled. Find a horizontal air vent
that is strong enough to hold the
weight of your MyFi and its cradle. Clip
the vent mount into the vent.
SWIVEL MOUNT: Find a suitable
location; the mount uses a strong
adhesive and you'll have difficulty
repositioning it after installation. Do
not install this mount on a leather
surface. Make sure the air temperature
is at least 60 F.
1. Clean the mounting surface with the
enclosed surface preparation kit.
Allow to air-dry.
2. Clean the same surface with the
alcohol prep pad. Allow to air-dry.
3. You may warm the adhesive pad
using a hair dryer or the vehicle's defroster. Place the swivel mount
accurately since it will bond on the first try.
4. For best results, do not touch or apply any pressure to the vehicle
mount for 72 hours.
To remove the swivel mount, first try lifting the adhesive pad with
your fingers or a spoon. You may warm it with a hair dryer for 2-3
minutes to help soften the adhesive. Remove any leftover adhesive
from the dash surface by rubbing with your finger, or you can use a
mild cleaner as recommended by your vehicle's manufacturer.