User's Manual

Make any FM radio an XM radio
Your MyFi contains a built-in FM transmitter that sends the XM audio
signal to any nearby FM radio home stereo, boombox, car radio, or
marine radio.
1. Turn on your FM radio, and turn off your MyFi. Unplug any
headphone or audio cable from your MyFi's headphone jack, and
any audio cables connected to the home stand or vehicle cradle.
2. You need to find an FM frequency that is not being used by any
commercial FM station.Tune your FM radio to the following FM
frequencies: 88.1, 88.3, 88.5, 88.7, 88.9, 106.7, 106.9, 107.1, 107.3,
107.5, 107.7, and 107.9. Note which frequency has no FM station or
the least amount of interference.
3. Turn on your MyFi.
4. Using the “menu” button and the dial, select “Set FM Frequency.”
5. Rotate the dial to highlight the FM frequency you found in step 2.
Press the dial in to select that frequency.
6. You should now hear XM programming on your FM radio. If the
sound isn't clear or you hear noise or static, try another FM
frequency. If you're traveling, you may need to retune periodically;
this is due to the differences in signal strength of local FM stations
and is not a problem with your MyFi.
TIP: When you plug headphones, a cassette adaptor, or an audio
cable into the headphone jack, your MyFi automatically turns off the
FM transmitter.
TIP: In the rare situation that you cannot find an open FM frequency,
consult a professional car audio installer. You can improve the audio
performance in your vehicle by using the Delphi FM Direct Adaptor
(model SA10112, sold separately).
Stock Ticker
With your MyFi, you can track up to 20 stock symbols and see their
prices and movements right on the screen.*
TO ADD A STOCK SYMBOL:
1. Using the “menu” button and dial, select “Stock Ticker.”
2. Rotate the dial to highlight “Add Stocks” and press dial in to select.
3. Rotate the dial to add each letter of the desired stock symbol. Press
the dial in after choosing each letter. (Your MyFi has a list of over
9000 stock symbols, and will not only help you complete each
entry but prevents you from entering incorrect symbols.) Confirm
the stock symbol is the stock you want to enter.
4. When you've entered all your desired stock symbols, press the
“menu” button several times (or simply wait a few seconds) until
your MyFi returns to normal operation.
5. Press the “display” button until you see “Stocks” and a scrolling
ticker across the bottom of the screen. This display mode only
works when you're listening to “LIVE” programming.