User's Manual

3
NOTE: 1. The FM antenna connector used to connect the FM Direct
Adapter to the vehicle audio/stereo system may require
an additional antenna adapter depending on the type of
vehicle. Professional installation is recommended.
2. The Audiovox FM Direct Adapter may be tie-wrapped to
existing wire harnesses or other under-dash structures.
The adapter should be constrained in some way to help
prevent it from causing rattles and other noise, or chafing to
vehicle wiring.
Interconnection Procedure
Interconnection Procedure
1. Connect the cable marked “TO XM RADIO” on the FM Direct adapter
into the XM antenna in jack on the XM vehicle dock or on the side of
the receiver.
2. Connect the cable marked “TO FM ANT” on the FM Direct adapter to
the vehicle FM antenna cable. (Optional antenna adapter may be
required, Refer to NOTE.)
3. Connect the vehicle FM antenna cable lead to the cable marked
“TO FM RADIO” on the FM Direct adapter. (Optional antenna adapter
may be required, Refer to NOTE.)
4. Connect the XM antenna into the jack marked “XM ANT” located on
the side of the FM Direct Adapter.
5. Your FM Direct Adapter receives power from your XM radio receiver.
No additional external power source is required.