Satellite Radio Receiver User Guide

Vehicle Installation

Step 2: Install the Vent or Dash Mount

Depending on your situation, you can either choose to use the Dash Mount or the

Vent Mount.

Installing the Dash Mount:

CAUTION! The adhesive used on the Dash Mount may be difﬁcult to remove. Do not

install this mount on leather surfaces (contact your vehicle dealer if you are unsure

about your dash surface), and make sure the air temperature is at

least 60°F (15°C) during installation. If it’s not at least 60°F, turn on

the heater in your vehicle to bring the temperature up to 60°F.

1 Locate a flat surface for the Dash Mount. Make sure

there is ample room for the PowerConnect Vehicle Dock

and Starmate 5 when installed.

2 Set the orientation of the Dash

Mount before adhering it. Loosen

the knob and adjust the adhesive

foot for the location you selected

in “Step 1: Choose a Location for

Your Radio” on page 16:

•Option 1 & Option 3 should be oriented

as I.

•Option 2 should be oriented as II.

3 Attach the Dash Mount to the

PowerConnect Vehicle Dock using the

provided screws.