ESR-T100 SIRIUS Satellite Radio Tuner User’s Manual
Thank you for purchasing this product. Please read this user’s manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e.g., glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. Contents 1. FEATURES ................................................................................................................... 1 2. PRECAUTIONS ...........................................................
2. PRECAUTIONS 1. 2. 3. 4. 5. 6. 7. Upon initial startup or when starting after turning off the backup power supply, the receiver will take longer to play audio and may take up to 30 seconds after reception of the SIRIUS signal before audio is heard. Channel names are stored in memory 30 to 60 seconds after start of normal operation. If the power is turned off before the text data is written, it may not be correctly displayed on the next power up.
car or home with much less concern for buildings, trees or other objects that might block conventional satellite signals. What is SIRIUS Satellite Radio? Once you experience over 110 channels of digital entertainment, you’ll never want to leave your car. For more information, visit www.sirius.com. Over 110 channels of the best entertainment and completely commercial-free music for your car, home or office.
3. INSTALLATION AND WIRING CONNECTIONS Before Installation 1. Before starting, be sure to disconnect the battery’s negative “–” terminal to prevent accidents due to short-circuits. 2. Location – Consider safety and operability when selecting a place for installation. Avoid the following. • Locations where the unit will hamper or interfere with driving. • Locations where the unit could injure passengers if the car stops suddenly. • Locations exposed to direct sunlight or hot air from the heater, etc.
Installation Example (Installing the unit under the driver’s seat) 1. Attach the mounting brackets to the sides of the ESR-T100 using the screws provided. 2. Select the location on the floor mat. Drill holes in the floor mat to match the positions of the holes in the mounting brackets . 3. Insert the canoe clips from the rear of the floor mat and install the SIR-CL1. There are three mounting holes on each side of the SIR-CL1. Select the appropriate holes to match to the installation location.
How to Connect 1. CDC Cable Orient the CDC cable in the direction shown in the figure and insert it until it is locked in position. To remove the CDC cable, pull it by lightly grasping the slide in your fingers. cap 2. SIRIUS antenna Make sure power is “Off”. Connect a SIRIUS antenna (sold separately) to the SIRIUS antenna terminal and press until locking tab engages. To disconnect, make sure power is “Off”, then press the rear of the locking tab to release.
4. SYSTEM EXAMPLE Main unit compatible with CDC connection CD changer compatible with CDC connection CDC cable (provided with the SIR-CL1) Using this cable, connect the SIR-CL1 to the main unit.
5. CONTROLS Source unit buttons, examples (ECD-T1540/ECD-T1545/ECD-T1560) [DSP] [ [ [LOC] [BND] [MOD] Notes: •Since this manual covers several models, the names of some buttons vary by model.
Display Items Source unit display, example Operation status indication Preset channel indication 9
6. SIRIUS OPERATION Selecting SIRIUS SATELLITE RADIO modes Press the [MOD] button to select the SIRIUS mode. The SIRIUS indication lights up when SIRIUS mode is selected. Notes: • The [MOD] button selects the external devices connected to the source unit in order, for example: AM/FM mode AUX mode SIRIUS mode CD changer mode etc. Selecting a band Press the [BND] button to select a band. Each press of the button changes the display as shown below.
Channel selection Channels are selected with the following buttons. or • The • A [LOC] button button (Seek Tuning) For details, see the following operation descriptions. Notes: •The audio output is muted and other button operations are not accepted during the channel selection process (tuning). Seek Tuning or button. The receiver seeks the next available channel 1. Press the below or above the current channel. The receiver moves to seek channels below or above the current channel.
Category selection function SIRIUS allows you to select broadcast channel by category. Receiving stations selected by category 1. Press the [LOC] button to enter the category selection mode. 2. Press [CD-] [CD+] to select the category. 3. Press or button to tune in a station from the Category. Notes: • When the category selection mode is entered, the category of the current or last received channel is displayed first.
SANYO MOBILE AUDIO MODEL ESR-T100 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user’s expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below.
