Instructions / Assembly

7
When attaching the springs, do not place your hands, arms, legs or any body parts close to the
connector points (i.e. joints connecting the steel tubes). The connector points can become pinch
points as the trampoline springs tighten up. Wear heavy duty working gloves to protect your hands
from pinching by the springs and protective goggles to avoid injuries to the eyes. Stay steady when
installing the springs as it can rebound and fly off if you inadvertently let go or springs not hooked
properly. Make sure no children are nearby when installing the trampoline.
STEP 3. Springs Assembly
Note: the two ends of the spring are different. Make sure to install the correct ends to the mat and rail
as shown below.
Starting from point “one”, hook the mat end of the Spring (#7) into the Triangle-Ring on the mat (#4). Holding
Spring Loading Tool (# 8) under hand, pull the other end of the spring and lock it into the corresponding hole
on the rail as shown in FIGURE 3.
After you have secured the spring at point “1”, attach springs to all Corner Top Rails (# 3) as shown in FIGURE
3. For even distribution of spring tension and ease of assembly, the springs must always be installed on
opposite sides of the mat in an alternating manner, i.e. Position 1, 36 followed by Position 18, 19; Position 6, 7
followed by Position 24, 25; Position 12, 13 followed by Position 30, 31 as shown below.
Hint: Tap on the Springs (# 7) by the Spring Loading Tool handle so springs can securely be latched into the hole of the
rail.
FIGURE 3
Mat
Rail
4
4
7