Installation Guide

Important
Installation Guide
Maintenance & Cleaning
The faucet can be cleaned by rinsing with clear water or washing with mild detergents. Dry the faucet with a clean, soft cotton cloth.
CAUTION: do not use any cleaning agents containing acids, abrasives, or other harsh chemicals.
Simply rinse and dry faucets with a soft towel every week to prevent mineral
deposits from forming. Clean spills and splatters as they happen. Do not let
soap, toothpaste or other contaminates dry on the faucet, this can stain or
pit the nish. Use a mild soap and soft sponge or towel to remove residue.
Rinse and dry thoroughly.
Never use an abrasive cleaner or rough sponge to clean or dry your faucet.
Harsh cleaners could dull or scratch the nish. Use only a soft disinfectant
that does not contain bleach or chlorine and apply with a soft towel.
Pull the spray head from the faucet body and disconnect by unscrewing it from the
hose. Once the spray head is disconnected, direct the open end of the hose into the
sink. Operate the faucet handle in the hot and cold positions to ush each line for at
least one minute. When complete, reconnect the spray head to the hose and place it
back into the faucet body.
To prevent damage to the tube body, tighten the connections by carefully using two
wrenches as shown. Use caution to not bend the stem.
Check for leaks.
Turn on the water supply SLOWLY, to test for leaks
before completely opening the water lines.
3